Epson PowerLite EB-720 Quick Setup page 2

Using the remote control
Install the two AA batteries as shown.
Turn projector on
and off
Access projector menus
Turn off projector
display and sound
For more information on using the remote control, see the online User's Guide.
Turn on your equipment
1
Turn on your computer or video source.
2
Make sure the power cord is connected and plugged into an
electrical outlet.
3
Press the power button on the projector or remote control. The
projector beeps, and the Status light flashes blue and then stays on.
Note: To shut down the projector, press the
4
If you don't see an image, press the Source Search button on the
remote control to select the image source.
Note: If you still see a blank screen or have other display problems, see
the troubleshooting tips on the back of this sheet.
5
If you need to focus the image, first slide the switch on the side of the
projector to open the air filter cover. Then raise or lower the focus lever
to sharpen the image.
Choose which source
to display
Navigate projector
menus
Control projector
volume
Access the Home
screen
power button twice.
6
Use the arrow buttons on the remote control to highlight any of the
options on the Home screen, then press
7
The default language of the menu system is English. To select another
language, press the Menu button on the remote control. Select
Management and press . Select Language and press
language and press . Press the Menu button to exit the menu system.
Wireless network
configuration
Follow these steps to set up the projector for a wireless network connection.
1
Press the Menu button on the remote control.
2
Select the Management menu and press
3
Select On as the Wireless LAN Power setting.
4
Select the Network menu and press
5
Select Network Settings and press
6
Select Wireless LAN as the Priority Control Interface setting.
7
Select one of the following as the Simple AP setting:
• On for a direct connection to a computer, tablet, or smartphone.
• Off to connect your projector to a router or access point.
Note: If you directly connect to the projector, you can only project locally-
stored content.
8
Select any other wireless settings as necessary. See the online User's Guide
for details.
9
When you are finished, return to the Network Settings menu and select
Set to apply your settings.
to select it.
. Select your
.
.
.