Advertisement
Run Wire Harness (1601-345)
Choose which side of the operator the arm is mounted on, remove knock-out and run wire harness accordingly as shown.
Note: Spacer
MUST be in
position when
installing a
reverse edge.
See page 6.
Plug in reverse edge.
Use bottom hole on arm bracket to secure cable grip.
IMPORTANT: Allow slack in the
wire harness between the cable
grips of at least 13" or more
for the rotating arm.
Install Arm Cover
IMPORTANT: Wire harness MUST
remain clear of the rotating arm and
the arm cover to avoid wire chaffing.
A r m
C o
v e r
Note for Older Covers:
See page 4.
1601-268-E-6-20
N e
a r
S i d
e
O p
t i o n
Use supplied adhesive
zip tie to secure harness
to bottom of bracket.
b l e
C a
p
G r i
K n
o c k
- O u
t
Wiring:
See page 3.
DO NOT operate arm with a
malfunctioning reverse edge.
2
F a r
S i d
O p
e
t i o n
C a
G r i
K n
o c k
- O u
t
IMPORTANT: Allow slack in the
wire harness between the cable
grips of at least 13" or more
for the rotating arm.
Note for Older Operators:
A 5/8" hole will have to be
drilled in the operator
cabinet approximately
where Knock-Out is
shown. Make sure 5/8"
hole is clear of all internal
components.
b l e
C a
p
G r i
b l e
p
Advertisement
