Adjusting Mounting Plate - Grizzly T31636 Owner's Manual

Adjusting
Mounting Plate
To ensure a workpiece does not catch on the
mounting plate and cause kickback, the mounting
plate must be adjusted evenly flush with the top
of the table.
Tools Needed:
Hex Wrench 3mm .............................................. 1
Straightedge 36" ................................................ 1
To adjust mounting plate:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove fence assembly from router table.
3.
Lay straightedge across mounting plate, table
insert, and table surfaces in pattern shown in
Figure 49. Adjust set screws (see Figure
50) in mounting plate as necessary so that
straightedge lies flat on table surface at all
positions of pattern.
Table Surface
Figure 49. Pattern for adjusting mounting plate.
Model T31636 (Mfd. Since 02/20)
Qty
Mounting
Plate
Straightedge
Figure 50. Example of using a straightedge to
align mounting plate with table surface.
IMPORTANT: Mounting plate and table
surface must be aligned evenly to ensure
workpiece does not catch on mounting plate
or table surface and kick back.
4. Repeat Step 3 as needed until mounting
plate is aligned with table surface.
5. Re-install fence assembly to table.
Set Screws
(1 of 4)
-29-