Table of Contents
Advertisement
SYSTEM OPTIONS
Input Select
Use this feature to reassign digital input/outputs, select the
input signal, rename the inputs, or adjust the level of the
signal input at each jack.
Choices: XM, TUNER, PHONO, CD, CD-R, MD/TAPE,
DVD, DTV, CBL/SAT, VCR1, DVR/VCR2,
V-AUX, MULTI CH
Note
Some parameters described below may not be available for all
input sources and some parameters are only available for specific
input sources.
Input source
XM
TUNER
PHONO
CD
CD-R
MD/TAPE
DVD
DTV
CBL/SAT
VCR1
DVR/VCR2
V-AUX
MULTI CH
1
Set AMP/SOURCE/TV to AMP and then press
GUI TOP on the remote control.
The top display appears.
AMP
SOURCE
TV
Stereo/Surround
Input Select
Manual Setup
Auto Setup
System Memory
80
Parameter
Antenna Level
Volume Trim
Rename
Volume Trim
Rename
I/O Assignment
Audio Select
Decoder Mode
Volume Trim
Rename
Audio Select
Decoder Mode
Volume Trim
Rename
Volume Trim
Multi CH Assign
GUI TOP
TITLE
BAND
Sound
Video
Basic
Option
2
Select Input Select and then press h.
Stereo/Surround
Input Select
Manual Setup
Auto Setup
3
Select the desired input source (CD, DVD,
etc.) and then press h to access and adjust.
■ Antenna Level (Antenna level)
Use to display the XM Satellite Radio reception level.
Input Select > XM > Antenna Level >
Display status: NONE, 0 to 100%
Antenna Level
Volume Trim
Rename
• If the displayed percentage of the reception level is
below the average (approximately 60%), you need to
adjust the orientation of the XM Satellite Radio
antenna for a better percentage of the reception level.
• If NONE is displayed, the XM Satellite Radio antenna
may not be firmly connected to the XM jack on the rear
panel of this unit. Check the XM Satellite Radio
connection.
Note
The Antenna Level parameter cannot be adjusted by using the
remote control. Instead, you need to adjust the orientation of the
XM Satellite Radio antenna for a better percentage of the
reception level.
CD-R
MD/TAPE
DVD
DTV
CBL/SAT
Antenna Level
100%
Advertisement
Table of Contents
