boho office BASIC LINE SQ650 Assembly And Operating Instructions Manual page 22

Additional settings
Installation of the memory control
>> Saving favourite positions <<
Save and set preferred heights using the number keys.
First the table must be moved to the desired position.
Press key „S" briefly - the display starts to flash.
Press the desired number key (1, 2, 3 or 4).
This height position is now stored on the corresponding number key. Pressing the number
key adjusts the table to the stored height.
>> Changing unit of length <<
Adjustment allows switching between metric (cm) and imperial (inch) on display.
1. Press and hold key „S"
2. Shortly after press „DOWN" and hold
3. Keep both pressed for ca. 3 secs -> Display shows then in inches. To change back,
repeat process.
4. Setting completed
>> Set Container Stop <<
Function serves to limit the low point of desk - once set - cannot be moved below the set-
stop point.
Adjust the height to the position where the stop point should be set.
1. Press and hold the key „S"
2. Shortly after, press and hold key „1"
3. Hold both pressed for ca. 3 secs
The display confirms the setting
Attention ! Favourite positions below the stop are deleted.
22
i