Auto Setup - Yamaha RX-V861 Owner's Manual

Troubleshooting
■ HDMI
Error message
DEVICE OVER
HDCP ERROR
Out of Res.
■ iPod
Note
In case of a transmission error without a status message appearing in the front panel and in the OSD, check the connection to your iPod
(see page 23).
Status message
Loading...
Connect error
Unknown iPod
iPod connected
Disconnected
Unable to play

■ AUTO SETUP

Before AUTO SETUP
Error message
Connect MIC!
Unplug HP!
102
En
Cause
The number of the connected HDMI
components is over the limit.
HDCP authentication failed.
Out of resolution. The connected video
monitor does not accept the output video
signals at the HDMI out jack.
Cause
This unit is in the middle of recognizing
the connection with your iPod.
This unit is in the middle of acquiring
song lists from your iPod.
There is a problem with the signal path
from your iPod to this unit.
The iPod being used is not supported by
this unit.
Your iPod is properly stationed in a
Yamaha iPod universal dock (such as the
YDS-10, sold separately) connected to the
DOCK terminal of this unit, and the
connection between your iPod and this
unit is complete.
Your iPod was removed from a Yamaha
iPod universal dock (such as YDS-10 sold
separately) connected to the DOCK
terminal of this unit.
This unit cannot play back the songs
currently stored on your iPod.
Cause
Optimizer microphone is not connected.
Headphones are connected.
Remedy
Reduce the number of the connected HDMI
components.
Check that the connected HDMI components support
the HDCP copy protection standards.
Set "HDMI UP SCALING" to "THRGH" or "480p"
(or "576p").
Remedy
Turn off this unit and reconnect the Yamaha iPod
universal dock to the DOCK terminal of this unit.
Try resetting your iPod.
Only iPod (Click and Wheel), iPod nano, and iPod
mini are supported.
Station your iPod back in a Yamaha iPod universal
dock (such as YDS-10 sold separately) connected to
the DOCK terminal of this unit.
Check that the songs currently stored on your iPod
are playable.
Store some other playable music files on your iPod.
Remedy
Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
Unplug the headphones.
See
page
—
—
81
See
page
23
—
—
23
—
—
See
page
28
—