Yamaha RX-V901 Owner's Manual page 14

9
Adjust the BALANCE control so that the effect sound
output level of the left front speaker and the right front
speaker are the same.
10
Adjust the sound output level of the center speaker to
be at the same level as that of the front speakers with
the CENTER LEVEL keys.
<
U.S.A., Canada
and Australia
models
CENTER LEVEL
Lights up.
14
9
BALANCE
0
l l
2 2
3 3
4 4
L 5 5 R
<
General
>
model
>
CENTER
LEVEL
TEST
CENTER
00
Adjustable
<
U.S.A.,Canada and
Australia models
CONCERT MONO
PRO LOGIC ENHANCED VIDEO MOVIE
1 2 3 4
SURROUND
STADIUM DISCO ROCK HALL
5 6 7 8
EFFECT
DSP
ON/OFF
10
CENTER LEVEL TEST
DELAY
TIME
REAR LEVEL
1
RESET CLEAR
12
11
Adjust the sound output level of the rear speakers to
be at the same level as that of the front speakers with
the REAR LEVEL keys.
<
U.S.A., Canada
and Australia
models
Lights up.
12
Cancel the test tone.
TEST
Notes
Once you have completed these adjustments, you can
adjust whole sound level on your audio system by using
the VOLUME control (or the VOLUME keys on the remote
control transmitter).
If you use external power amplifiers, their volume controls
may also be adjusted to achieve proper balance.
In step 10, if the center channel mode is in the
"PHANTOM" position, the sound output level of the center
speaker cannot be adjusted. This is because in this mode,
the center sound is automatically output from the left and
right front speakers.
<
Australia model only
If there is insufficient sound output from the center and
rear speakers, you may decrease the front speaker output
level by setting the FRONT LEVEL switch on the rear
panel to "–10 dB".
<
General model
>
VCR 2
REC PAUSE
V–AUX
12
TEST
MASTER
VOLUME
PRO LOGIC
10
CENTER
LEVEL MONO MOVIE
11
REAR
LEVEL
<
General model
>
REAR LEVEL
REAR
LEVEL
TEST
REAR
0
Adjustable
TEST
R
Stops flashing and disappears
>
>
DIR A PLAY DIR B TAPE MON
STOP LD/TV
ENHANCED CNCT VIDEO VCR 1
SUR.
STADIUM DISCO VCR 2
EFFECT
ON/OFF
ROCK HALL V AUX
DELAY TIME VOLUME
>