Final Installation Check - LG ADFD5448AT Owner's Manual

DW_SNA_MFL71467502_00_200727_00_EN.book Page 19 Monday, July 27, 2020 7:19 PM
2
Attach a custom toe kick. If needed, use a saw
to cut a notch in the top of the custom toe kick
to provide clearance for the cabinet panel
when opening the door.

Final Installation Check

Testing the Dishwasher
Check if the dishwasher is properly installed.
1
Turn on the circuit breaker.
2
Turn on the house water supply.
3
Make sure that the door opens and closes
smoothly.
• If necessary, level the dishwasher again.
• If the door will not close, make sure the rack
is level.
• Make sure that all packaging materials have
been removed.
4
Power on the dishwasher and run a Turbo
cycle to verify proper operation.
5
Check for leaks at the drain hose and water
supply connection.
6
If a water leak is detected, press and hold the
Start button for 3 seconds to cancel the wash
cycle and automatically drain the water from
the dishwasher. Tighten all water connections
and run another cycle. Repeat until no leaks
are detected.
Installation Check Error Codes
Refer to the chart below before calling for service.
Error Code Possible Cause and Solution
Drain hose is kinked or pinched.
OE
• Feed the drain and water
supply hoses through the hole
under the sink. Then gradually
slide the dishwasher into the
cabinet while pulling on the
hoses under the sink to take up
any slack. This helps avoid
kinking the hoses or trapping
them beneath the dishwasher.
Drain hose is connected to the
disposal without removing the
knockout plug.
• Remove the knockout plug
from the disposal.
Waste tee or disposal is clogged.
• Remove knockout plug on the
waste tee or disposal.
INSTALLATION 19