Ultratec G3000 Operator's Manual page 6

D=DEMAND; This value represents the user's
requested fog output level from 1-100%
REM = Fog machine is controlled
currently by the remote
Fog = Machine is generating
fog. WIll read "Fog Off" when
currently not generating fog.
DMX=Fog machine is
controlled through DMX.
Remote bypassed.
DMX Address
CYCLE ON TIME
CYCLE OFF TIME
LSG PRE-FOG TIME
DMX Address: 511
Data
6
www.ultratecfx.com
REM
Fog
Displays the Cycle On Time, Cycle
Off Time, and LSG Pre-Fog Time
DMX
511
0:00 (mm:ss)
0:00 (mm:ss)
0:00 (mm:ss)
0 D+1
0-255
A=ACTUAL; This value represents the current level of
fog output in relation to DEMAND due to cooler block
temperatures.
D100 A100
0:00 FHR
F = LOW FLUID DETECTION; F will display when
sensor detects low fluid. Machine will continue to
run or can be set to shut off when sensor activates.
0
0-255
128 - Relay
R = RELAY; R appears when the G3000
is powering the LSG receptical.
H = HEATING; H will display when the blocks
are heating up. H will disappear when block
is heated to desired temp.
Set the desired time for the fog machine to
run, using the "+" or "-" buttons.
(0-10 Minutes)
Set the desired time for the fog machine to
stop, using the "+" or "-" buttons.
(0-30 Minutes)
When connected to an LSG, set the desired
time for the LSG to purge the CO2 line before
the G3000 begins to produce fog.
(0-2 Minutes)
Using the "+" or "-" buttons select the
desired valid DMX address. (0-511)
Data = fog rate controlled 0-100%,
DMX+1=LSG power on above 50%.
TEMPERATURE BAR
Displays the block
temperature.