Troubleshooting - Yamaha RX-V359 Owner's Manual

TROUBLESHOOTING

Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
YAMAHA dealer or service center.
General
Problem
This unit fails to turn
on or enters the
standby mode soon
after the power is
turned on.
No sound
60
TROUBLESHOOTING
Cause
The power cable is not connected or the
plug is not completely inserted.
The speaker impedance setting is
incorrect.
The protection circuitry has been
activated.
This unit has been exposed to a strong
external electric shock (such as lightning
or strong static electricity).
Incorrect input or output cable
connections.
No appropriate input mode has been
selected.
No appropriate input source has been
selected.
Speaker connections are not secure.
The front speakers to be used have not
been selected properly.
The volume is turned down.
The sound is muted.
Signals this unit cannot reproduce are
being input from a source component,
such as a CD-ROM.
Remedy
Connect the power cable firmly.
Set the speaker impedance to match your speakers.
Make sure that all speaker wire connections on this
unit and on all speakers are secure and that the wire
for each connection does not touch anything other
than its respective connection.
Set this unit to the standby mode, disconnect the
power cable, plug it back in after 30 seconds and then
use it normally.
Connect the cables properly. If the problem persists,
the cables may be defective.
Select an appropriate input mode.
Select an appropriate input source with INPUT l /
h on the front panel (or the input selector buttons on
the remote control) and MULTI CH INPUT on the
front panel (or MULTI CH IN on the remote control).
Secure the connections.
Select the front speakers with SPEAKERS on the
front panel or SPEAKERS A/B on the remote control.
Turn up the volume.
Press MUTE or VOLUME +/– on the remote control
to resume audio output and then adjust the volume.
Play a source whose signals can be reproduced by this
unit.
See
page
—
9, 11
11
—
13-17
26
23, 25
11
23
—
25
—