To Play A Source With The Digital Sound Field Processor - Yamaha RX-V10 Owner's Manual

1
Follow steps 1 – 6 shown in "BASIC OPERATIONS" on
page 20.
2
Turn the DSP on, so that a program name appears on
the display.
PROGRAM
or
* Pressing the PROLOGIC or ENHANCED key turns
the DSP on and selects the corresponding program
directly. (If you press either of these buttons, you can skip
step 3.)
3
Select the desired program that is suitable for the
source.
PROGRAM
or
The selected program name is shown on the display.
32

To play a source with the digital sound field processor

2, 3
EFFECT
ON/OFF
PROLOGIC ENHANCED
PROGRAM
PRO LOGIC
DELAY/REAR
– +
LEVEL /CENTER
3
PROGRAM PROLOGIC
DIR A DIR B REC/PAUSE
– +
A/B/C/D/E
PRESET
4
If desired, adjust the delay time and the output level of
each speaker. (For details, refer to the corresponding
descriptions on page 33 and 34.)
Notes
If you prefer to cancel the DSP, press the EFFECT key.
The sound will be the normal 2-channel stereo without
surround sound effect.
When CONCERT VIDEO, MONO MOVIE, ROCK
CONCERT or CONCERT HALL is selected, no sound is
heard from the center speaker.
When a monaural sound source is played with DOLBY
PRO LOGIC or DOLBY PRO LOGIC ENHANCED, no
sound is heard from the front speakers and the rear
speakers. Sound is heard only from the center speaker.
However, if the center channel mode is in PHANTOM, the
front speakers output the sound of the center channel.
When this unit's Dolby Pro Logic Surround system is used,
if the main-source sound is considerably altered by
overadjustment of the BASS or TREBLE control, the
relationship between the center and rear channels may
produce an unnatural effect.
2
TEST EFFECT
ON/OFF
2
ENHANCED
DVD/LD
VCR 2CH/5CH
PLAY
TAPE
A/B
TUNER