Front Panel Display - Yamaha RX-497 Owner's Manual

f_.... _ _FI ....
(U.S.A. model)
@ MASTER ON/OFF
Press inward to the ON position to turn on the power of
this unit. Press again to release it outward to the OFF
position to turn off this unit.
See page 14 for details.
Even when this unit is turned ofi2 this unit consumes a small
amount of power to preserve the memo13".
Memory back-up
The memory back-up circuit prevents the stored data
from being lost. However, the stored data will be lost if
the power cord is disconnected from the AC wall outlet
for more than one week.
@ MAIN ZONE ON/OFF
Turns on Main Zone of this unit or sets it to the standby
anode.
See page 14 for details.
• This switch is operational only when MASTER ON/OFF is
pressed inward to the ON position.
• In the standby mode. this trait consmnes a small amount of
power to receive infrared signals from the remote control.
@ ZONE 2 ON/OFF
Turns on Zone 2 or set it to the standby anode. When Zone
2 is turned on, signals are output at the ZONE 2 OUT
jacks.
This switch is operational only when MASTER ON/OFF is
pressed inward to the ON position.
@ ZONE CONTROL
Press to control the input source of Zone 2.
• This button is operational only when Zone 2 is turned on.
• When you press this button, the ZONE 2 indicator flashes in the
front panel display for approximately 5 seconds. Select the
inpm soarce of Zone 2 while the indicator is flashing.
• You can select the preset station or channel when TLrNER or
XM is selected as the input source of Zone 2.
@
Remote control sensor
Receives infrared signals from the remote control.
Switch the remote control ID between ID1 and ID2 when using
multiple YAMAHA receivers or amplifiers (see pages 35, 36).
@
Front panel display
Shows information about the operational status of this
unit.