Advertisement
Resetting the Lamp Hour Timer:
If the projector is being controlled using IP control go back to page 13.
If the projector is being controlled by PSA control software via RS-232 proceed to the next step.
- Connect to the projector using PSA software.
- On the controlling computer, press Ctrl + Shift + T at the same time - a Password menu will appear.
- Enter password PALI123 and click OK – a menu for resetting parameters will appear.
- Enter value "000000" (six digit hexadecimal) into the box to the right of either Lamp 1 Time or
Lamp 2 Time and press the Enter key to write the value into the projector.
- Power up the projector from the Main menu and test the operation.
- END
JPC20118
© 2011 JVC U.S.A
14
Advertisement
