Carbest Multi-Sat X65 Instruction Manual page 27

13
Parts required, spanner, four(4) nuts
15
Fit the supplied nuts to each of the four bolts
and tighten firmly with spanner
17
Connect signal cable to antenna port and place cable holder bottom next to the center of the antenna
base and then apply masking tape 5mm from the outside of the cable holder bottom
※ To prevent the damage of cable, cable shaping is necessary. By referring the
above image, arrange the cable from the antenna base port straight in 6 cm, and
then bend it to cable holder bottom.
18
Drill a 25mm hole in the centre of the tape
marking
Place the antenna on the aluminium plate and
place the washers over each bolt
Make sure you check and four (4) nuts are
tightened
6 cm
Make sure that hole size is minimum so that the
cable can pass through
ENGLISH - 25
14
16
19