Eaton xComfort CHCA-00 Assembly Instructions Manual page 12

sure on the devices or strain on connection wires).
 xComfort devices MUST NOT be changed, neither in technical, mechanical and/or electrical
terms. Exception: Shortening of connection wires.
 Devices must not be opened.
 xComfort devices must be and stay accessible for programming, replacement and mainte-
nance purposes (i.e. NO wall-paper on distribution boxes, NO immuring etc).
 Torques for screw-type terminals on the device need to be respected! For terminals from
third-party suppliers (e.g. lustre terminals) you need to respect the manufacturers' technical
data.
 Once the job has been done, all the installation boxes need to be closed again. All live com-
ponents need to be touch-proof.
 Installation boxes and distributors must be flame-retardant in compliance with the respective
rules and regulations.
 Neutral conductor displacements in the system network used are NOT allowed and can
destroy/damage the devices.
 Phase and neutral conductor need to be correctly connected.
 Protective earth PE needs to be provided where required by terminal equipment (e.g. lamp
with a metal housing).
 After removing any xComfort actuators, the incoming capacitor of the actuators needs to be
discharged (risk of electric shock).
 Connecting the sensors and loads or consumers has to be done in accordance with the
technical section of our catalogue or with the mounting instructions supplied with each pro-
duct. All technical data and recommendations need to be respected.
 Any connection wires not used must be touch-proof.
 Country-specific waste disposal and environmental regulations (e.g. for defective devices,
batteries, ...) need to be respected.
Applications:
 xComfort products MUST NOT be used for safety installations and safety-relevant functions,
especially for:
 Safety temperature switches and limiting equipment of heating systems
 Final position detection and switch-off or safety functions related to the influence of the
weather on shading systems (wind,rain,hail ...)
 Safety and EMERGENCY STOP functions in general
 Conventional fire alarm systems
12