Uefi Bios; Enter The Uefi Bios Menu; Navigate In The Uefi Bios Interface - Lenovo ThinkPad X1 Fold Gen 1 User Manual

• If you have set a supervisor password and remember it:
1. Enter the UEFI BIOS menu. See "Enter the UEFI BIOS menu" on page 31. Enter the supervisor
password when prompted.
2. Select Security ➙ Password ➙ System Management Password.
3. Enter the current supervisor password in the Enter Current Password field. Then, leave both the
Enter New Password and Confirm New Password field blank, and tap Save.
4. In the Changes have been saved window, tap Continue.
5. Tap F10 to save changes and exit the UEFI BIOS menu.
• If you have not set a supervisor password, contact a Lenovo authorized service provider to have the
system management password removed.
What to do if you forget your hard disk password
If you forget your user hard disk password or both user and master hard disk passwords, Lenovo cannot
reset your passwords or recover data from the storage drive. You can contact a Lenovo authorized service
provider to have the storage drive replaced. A fee will be charged for parts and service.
What to do if you forget your supervisor password
If you forget your supervisor password, there is no service procedure to remove the password. You have to
contact a Lenovo authorized service provider to have the system board replaced. A fee will be charged for
parts and service.

UEFI BIOS

UEFI BIOS is the first program that the computer runs. When the computer turns on, UEFI BIOS performs a
self test to make sure that various devices in the computer are functioning.

Enter the UEFI BIOS menu

To enter the UEFI BIOS menu, do the following:
1. Restart the computer. When the logo screen is displayed, tap the prompt. The Startup Interrupt Menu
window is displayed.
2. In the Startup Interrupt Menu window, tap F1 to enter the UEFI BIOS menu.
Note: If you have set the supervisor password, enter the correct password when prompted. You also can
press Enter to skip the password prompt and enter the UEFI BIOS menu. However, you cannot change the
system configurations that are protected by the supervisor password.

Navigate in the UEFI BIOS interface

You can navigate in the UEFI BIOS interface by using the following:
• F1: General Help
• F9: Setup Defaults
• F10: Save and Exit
• F5 / F6: Change boot priority order
• ↑↓ or PgUp / PgDn: Select / Scroll page
• ← →: Move keyboard focus
• Esc: Back / Close dialog
• Enter: Select / Open submenu
.
Chapter 4 Configure advanced settings
31