Table of Contents
Advertisement
Maintenance
D. Remove the Ice Thickness Probe
• Compress the side of the ice thickness probe
near the top hinge pin and remove it from the
bracket.
COMPRESS SIDES OF ICE
THICKNESS PROBE
Ice Thickness Probe Removal
NOTE: At this point, the ice thickness probe can easily
be cleaned. If complete removal is desired follow the ice
thickness probe wire to the bulkhead grommet (exit
point) in the back wall. Pop the bulkhead grommet out of
the back wall by inserting fingernails or a flat object
between the back wall and the grommet and prying
forward. Pull the bulkhead grommet and wire forward
until the connector is accessible, then disconnect the
wire lead from the connector.
Ice Thickness Probe Cleaning
•
Mix a solution of Manitowoc ice machine cleaner and
water (2 ounces of cleaner to 16 ounces of water) in
a container.
•
Soak the ice thickness probe a minimum of 10
minutes.
Clean all ice thickness probe surfaces and verify the ice
thickness probe cavity is clean. Rinse thoroughly with
clean water, then dry completely. Incomplete rinsing and
drying of the ice thickness probe can cause premature
harvest.
4-2
ICE THICKNESS
PROBE
E. Remove the Water Distribution Tube
ES170/ES210/ES270 Models
1. LIFT UP
2. SLIDE BACK
3. SLIDE TO RIGHT
DISTRIBUTION
TUBE
THUMBSCREW
ES170/ES210/ES270 Water Distribution Tube
Removal
•
Loosen the two thumbscrews, which secure the
distribution tube.
•
Lift the right side of the distribution tube up off the
locating pin, then slide it back and to the right.
Do not force this removal. Be sure the locating pin is
clear of the hole before sliding the distribution tube
out.
Disassembly
•
Twist both of the inner tube ends until the tabs line up
with the keyways.
•
Pull the inner tube ends outward.
INNER TUBE
ES170/ES210/ES270 Water Distribution Tube
Disassembly
Section 4
2
3
THUMBSCREW
LOCATING
PIN
! Caution
INNER TUBE
TAB
KEYWAY
Part Number 040005094 05/19
1
Advertisement
Table of Contents
