Table of Contents
Advertisement
Installation Instructions
Location of Ice Machine
The location selected for the ice machine must meet the
following criteria. If any of these criteria are not met,
select another location.
•
The location must be free of airborne and other
contaminants.
•
The air temperature must be at least 5°C, but must
not exceed 43°C.
•
The location must not be near heat-generating
equipment or in direct sunlight.
•
The location must be capable of supporting the
weight of the ice machine and a full bin of ice
•
The location must allow enough clearance for water,
drain and electrical connections in the rear of the ice
machine.
•
The location must not obstruct air flow through or
around the ice machine. Refer to the chart below for
clearance requirements.
Self-Contained
Air-Cooled
Top/Sides
203 mm
Back
127 mm
*There is no minimum clearance required for water-cooled or remote
ice machines. This value is recommended for efficient operation and
servicing only.
Ice Machine Heat of Rejection
Series
Ice Machine
Conditioning**
ES90
ES130
ES170
ES210
ES270
*
B.T.U./Hour
**
Because the heat of rejection varies during the ice making cycle,
the figure shown is an average.
Ice machines, like other refrigeration equipment, reject
heat through the condenser. It is helpful to know the
amount of heat rejected by the ice machine when siz-
2-2
Self-Contained
Water-Cooled*
203 mm
127 mm
Heat of Rejection*
Air
Peak
1750
2600
2400
2900
2400
3200
2400
3400
3800
6000
ing air conditioning equipment where self-contained
air-cooled ice machines are installed.
Leveling the Ice Machine
1. Screw the leveling legs onto the bottom of the ice
machine.
2. Screw the foot of each leg in as far as possible.
The legs must be screwed in tightly to prevent
them from bending.
3. Move the ice machine into its final position.
Do not obstruct ice machine vents or openings.
4. Level the ice machine to assure that the siphon
system functions correctly. Use a level on top of the
ice machine. Turn each foot as necessary to level
the ice machine from front to back and side to side.
Section 2
! Caution
!
Warning
Screw the foot of
each leg in as far
as possible
Part Number 040005094 05/19
Advertisement
Table of Contents
