Yamaha DSP-A590 Owner's Manual page 13

6
6
Select the center channel output mode according to your
speaker configuration.
(Refer to "SPEAKER CONFIGURATION" on page 6.)
CENTER
MODE
On the feature of each mode, refer to the "Note" shown
below.
Note
In step 6, when you select the center channel output mode,
note the following.
For 5 speaker configuration)
NORMAL: Select this mode when you use a center speaker
that is smaller than the front speakers. In this
mode, the bass tone will be output from the front
speakers.
WIDE: Select this mode when you use the center speaker
approximately same sized as the front speakers.
For 4 speaker configuration)
PHANTOM: Select this mode when you do not use the center
speaker. The center sound will be output from the
left and right front speakers.
8
NORMAL
WIDE
PHANTOM
REC PAUSE
7
TEST
CENTER
LEVEL MONO MOVIE
REAR
LEVEL
8
7
TEST
8
Turn up the volume.
You will hear a test tone (like pink noise) from the left front
speaker, then the center speaker, then the right front
speaker, and then the rear speakers, for about two
seconds each. The display changes as shown below.
Front (L) Center
Rear Front (R)
(L and R)
* The test tone from the left rear speaker and the right rear
speaker will be heard at the same time.
DIR A PLAY DIR B TAPE MON
STOP LD/TV
PRO LOGIC ENHANCED CNCT VIDEO VCR 1
SUR.
STADIUM DISCO VCR 2
EFFECT
ROCK HALL ON/OFF V AUX
DELAY TIME VOLUME
TEST
ER
Flashes continuously.
VOLUME
TEST
CONTINUED
13