Operation - Field Controls VentCool Summit S-Class Series Installation Manual

OPERATION

Before starting this fan for the rst time, verify that:
• All wiring and connection have been made according to this manual and all applicable wiring codes and
standards.
• No tools or construction debris have been left in, on or around the fan.
• Dedicated 115VAC, 15 AMP power outlet has been properly installed and plug terminal outlet orientation is
correct.
• Wall control is installed properly. Plug&Play cable is installed and connected properly between wall control and
fan assembly.
• Open windows to allow for outside air to enter space.
• Verify that Functional Check in INSTALLATION: WIRING & CONTROLS section has been completed prior to home
owner use.
• Verify grille is installed below damper assembly.
1. Verify fan power cord is plugged into dedicated 115VAC, 15 AMP outlet.
2. Turn ON dedicated fan assembly power outlet. LCD on wall control should lite up.
3. Press ON/OFF button on WTT to turn ON the whole house fan.
The wall control can operate in two di erent modes of operation: Temperature or Timer Control
Temperature control will allow the homeowner to set the indoor temperature at which the whole house fan system
will turn o once temperature is reached. Timer control will allow the homeowner to set how much time in hours
the whole house fan will operate before turning o .
FIGURE 10 : STANDARD WALL CONTROL SYSTEM
(SPEED TEMPERATURE OR TIME)
page 13 of 20 P/N 780104700 03/20 Rev A