The Splash Lab Aerofoil Installation And Maintenance Manual

Wall mounted basin
Hide thumbs Also See for Aerofoil:

Advertisement

TSL-Aerofoil
wall mounted basin

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Aerofoil and is the answer not in the manual?

Questions and answers

Summary of Contents for The Splash Lab Aerofoil

  • Page 1 TSL-Aerofoil wall mounted basin...
  • Page 2 Contents Technical Data Before You Install Assembly How to Install Maintenance Cleaning Warranty Contact Details TSL-AEROFOIL WALL MOUNTED BASIN MANUAL...
  • Page 3 FIXINGS M5X12 COUNTERSUNK SCREW M8X12 COUNTERSUNK SCREW M6X14 PAN HEAD M8X12 CONE POINT M8 TEE NUT M6 TEE BOLT WASHER M6 NUT FIXING TAPE ADDITIONAL REQUIREMENTS NOT SUPPLIED BY THE SPLASH LAB SILICONE WALL FIXINGS TSL-AEROFOIL WALL MOUNTED BASIN MANUAL...
  • Page 4: Technical Data

    46.50 21.00 67.50 1800mm TSL-103QZ 69.00 29.50 98.50 2400mm TSL-104QZ 92.00 38.00 130.00 Warranty 5 years from date of purchase (terms and conditions apply) Material Solid surface Marble Quartz Mounting frame Aluminium and powder-coated steel TSL-AEROFOIL WALL MOUNTED BASIN MANUAL...
  • Page 5: Before You Install

    Wall fixings are not included with the aerofoil. If the void is less than 92mm or wall construction not suitable for fixing the Aerofoil to, an additional wall cavity will have to be created.
  • Page 6 Access Required Above Washplane For Initial Installation And Ongoing Routine Maintenence. LENGTH TSL-880 And TSL-470 Series (Not Included) See Seperate Data Sheet 67mm 533mm 600mm 1-1/4" Waste Access Required Below Washp For Initial Installation And Ongo Routine Maintenence. TSL-AEROFOIL WALL MOUNTED BASIN MANUAL...
  • Page 7 See Seperate Data Sheet 67mm 533mm 600mm 600mm 533mm 67mm 1-1/4" Waste Access Required Below Washplane For Initial Installation And Ongoing 1-1/4" Waste Routine Maintenence. Access Required Below Washplane For Initial Installation And Ongoing Routine Maintenence. TSL-AEROFOIL WALL MOUNTED BASIN MANUAL...
  • Page 8 (P9) leaving it loose. the tee nut will turn 90degrees and lock in place. Make sure that the position of the plates aligns with the marker on the main body and that it is plumb level. TSL-AEROFOIL WALL MOUNTED BASIN MANUAL...
  • Page 9 (P2) with M5x12 countersunk screw (F1). Knock in Cantilever end cap (P6,P7) Slide grate into the Main body (P2) and for the cantilever(P3) and apply a small secure with tape (F9). amount of adhesive. TSL-AEROFOIL WALL MOUNTED BASIN MANUAL...
  • Page 10 . the tee nut will turn 90degrees and lock in place. Make sure that the position of the plates aligns with the marker on the main body and that it is plumb level. TSL-AEROFOIL WALL MOUNTED BASIN MANUAL...
  • Page 11: How To Install

    (see drawing on page 5). Fix assembly to the wall with appropriate Adjust any loose feet so they are firmly fixings, again making sure that the on the floor. assembly is plumb level. TSL-AEROFOIL WALL MOUNTED BASIN MANUAL...
  • Page 12 (F3) washer (F7). underside. Then clamp in place with the clamping feet (P8). Apply silicone seal (A1) down the side of Remove tape (F9) Slide grate (P15) into the joining. position. TSL-AEROFOIL WALL MOUNTED BASIN MANUAL...
  • Page 13 (P2) and tighten the fixing. As it tightens the tee nut will turn 90degrees and lock in place. Soap feeds and water can either go Check that everything is watertight. around the aerofoil or through the channels at the back. TSL-AEROFOIL WALL MOUNTED BASIN MANUAL...
  • Page 14: Maintenance

    The Aerofoil should be thoroughly cleaned once every year to prevent blockages and build up of dirt. There are two ways to clean the water trough. Method 1, remove the waste (P16) to access the slot below the washplane.
  • Page 15 Dichloromethane, Sodium hydroxide - caustic soda, paint strippers, acid drain cleaners, degreasing agents. If any of the above are used, it should be flushed promptly with clean water to avoid damage to the surface. Keep away from UV lighting TSL-AEROFOIL WALL MOUNTED BASIN MANUAL...
  • Page 16 If any of the above are used, it should be flushed promptly with clean water to avoid damage to the surface. TSL-AEROFOIL WALL MOUNTED BASIN MANUAL...
  • Page 17: Warranty

    5 years’ parts & labour, plus an additional 4 years parts only If a defect is found in normal use, The Splash Lab. will, at their discretion, repair, provide a replacement part or product, or make appropriate adjustments. Damage caused by accident, misuse, or abuse is not covered by this warranty.
  • Page 18 General information info@thesplashlab.com +44 (0) 161 482 7000 Technical support technical@thesplashlab.com For further contact information visit: www.thesplashlab.com TSL-AEROFOIL WALL MOUNTED BASIN MANUAL...
  • Page 19 TSL-AEROFOIL WALL MOUNTED BASIN MANUAL...

Table of Contents