Connecting To Line Output Terminals - Yamaha YST-SW150/80 Owner's Manual

CONNECTING TO LINE OUTPUT (PIN JACK) TERMINALS OF THE AMPLIFIER
• Leave the main speakers connected to the amplifier.
• Amplifier line output terminals are generally labeled PRE OUT or SUBWOOFER OUT.
* For PRE OUT terminal connection, the amplifier must possess at least two sets of PRE OUT terminals. With some amplifiers
with only one set of PRE OUT terminals, connection can result in no sound from the main left and right speakers. In this
case, select the method of connecting to the speaker terminals.
• To connect with a YAMAHA DSP amplifier, connect the LOW PASS (or SUBWOOFER etc.) terminal on the rear of the DSP
amplifier to either the left (L) or right (R) INPUT 2 terminal.
If using one unit
Left speaker
Amplifier
If using two units
Left speaker
This unit
OUTPUT INPUT2 AUTO PHASE
TO SPEAKERS POWER
ON OFF NOM REV
FROM AMPLIFIER
INPUT1
To AC outlet
Notes
• When connected to line output terminals of the amplifier, other speakers should not be connected to the OUTPUT terminals on
the rear panel of this unit. If connected, they will not produce sound.
• When connecting to a monaural line output terminal of the amplifier, connect to either the left or right INPUT 2 terminal.
This unit
OUTPUT
TO SPEAKERS
OUTPUT INPUT2 AUTO PHASE
POWER
TO SPEAKERS
ON OFF NOM REV
FROM AMPLIFIER
INPUT1
FROM AMPLIFIER
INPUT1
To AC outlet
OUTPUT INPUT2 AUTO PHASE
POWER
TO SPEAKERS
ON OFF NOM
FROM AMPLIFIER
INPUT1
This unit
OUTPUT INPUT2 AUTO PHASE
TO SPEAKERS POWER
ON OFF NOM REV
FROM AMPLIFIER
INPUT1
To AC outlet
INPUT2 AUTO PHASE
POWER
ON OFF NOM REV
<
YAMAHA DSP amplifier
LOW PASS
< >
Amplifier
PRE OUT
OUTPUT INPUT2
TO SPEAKERS
REV
FROM AMPLIFIER
INPUT1
Amplifier
>
Pin plug cords
AUTO PHASE
POWER
ON OFF NOM REV
Pin plug
cords
PRE OUT
Right speaker
Right speaker
7