Projection; Checking Installation And Connections - Yamaha DPX-1300 Owner's Manual

8 Projection

Checking installation and connections

Pre-operation check
Prior to projection, adjust settings to suit the location of the main unit and screen, and the input signal you are using.
However, there is usually no need to adjust any settings if you have not changed the installation location or components since the last time
you used this unit. Check settings and connections only when the unit does not appear to project images correctly.
Prior to projection, check that the main unit and screen are correctly installed, and that source components are connected correctly.
Is the screen installed correctly?
"Setting up the DPX-1300"
To project images, carry out the following procedure.
Check installation and connections
Select an image for projection and image adjustment
Turn on the projector power.
Begin playback of the source image for adjustment.
Select a projection image.
(Select an input signal and projection image aspect.)
Adjust focus and vertical/ horizontal positioning.
Projection preparations complete
For an explanation of detailed settings, see "Menu".
Main unit
Image source component
page 12
PURE DIRECT
2CH/MULTI CH
INPUT SELECTOR
STANDBY
/ON
page 27 - 47
Are the components connected correctly?
"Connecting to AV components"
VOLUME
REC OUT/ZONE 2
SOURCE/REMOTE MULTI JOG BALANCE
DTV/LD DVD
SPEAKERS CABLE MD/TAPE MULTI CH DSP
A B SAT CD-R INPUT MODE INPUT STRAIGHT PROGRAM
VCR 1 CD
TONE
VCR 2 TUNER EFFECT CONTROL
DVR PHONO
VIDEO AUX
SILENT OPTIMIZER VIDEO AUX
MIC
PHONES S VIDEO VIDEO L AUDIO R OPTICAL
Is the main unit power
turned on?
page 15 - 16
Is the source component power
turned on?
8
17