Sharper Image SI-380 Owner's Manual page 15

STEAM MOPPING
NOTE: Be sure that Reservoir has been filled and that all steam mopping accessories are
connected before following these steps.
It is recommended to sweep or vacuum hard floors before mopping.
1. Follow STEPS 1-3 of Steam Cleaning section.
Refer to Page 11 for a listing of hard floor surfaces that are recommended for cleaning with
the Canister Steam Cleaner.
2. For best results, use a steady back-and-forth motion over floor surface, pushing the Mop
Head away and pulling it back towards you. Work your way backwards over the floor, in
order to avoid walking over freshly mopped areas.
NOTE: To avoid warping or damage caused by heat and moisture, do not use on unsealed
hardwood or unglazed ceramic surfaces. Steam may remove the sheen from some floors
that have been treated with wax.
3. To effectively kill bacteria and microorganisms, repeatedly mop a single small area
(approximately 3' x 3' for best results) for at least 2 minutes.
4. The Microfiber Pad will absorb dirt and moisture during mopping. However, when you
are finished you may find some residual moisture has been left behind. In this case, it is
recommended to allow floor time to air-dry. A fan may be directed towards mopped
area to facilitate drying.
English 15