Sharper Image SI-380 Owner's Manual page 12

STEAM CLEANING ACCESSORIES
WARNING: Do not connect accessories while unit is emitting steam.
JET NOZZLE / SCRAPER
1. Select Jet Nozzle or Scraper and push onto the Steam Nozzle (A).
2. Rotate accessory until the orange lock/release button snaps into the accessory hole (B).
NOTE: The Jet Nozzle and Scraper can be connected to the end of an Extension Wand for
reaching high or difficult spots. Connect the Extension Wand (or Wands), then connect
your desired accessory to the Wand in the same way as you would normally connect to
the Steam Nozzle.
A
B
Steam Nozzle
UTILITY BRUSHES / ANGLED NOZZLE
NOTE: Accessories connect to the Jet Nozzle, not the Steam Nozzle.
1. Firmly press accessory onto tip of Jet Nozzle. Press it on as far as possible to prevent
steam leakage (See figure 3).
2. To remove accessory, simply grip it firmly and pull it off Jet Nozzle.
FIGURE 3
12 English