Engine Stop Lanyard Switch; Main Switch - Yamaha F50D Owner's Manual

Basic components
EMU25990

Engine stop lanyard switch

The lock plate must be attached to the en-
gine stop switch for the engine to run. The
lanyard should be attached to a secure place
on the operator's clothing, or arm or leg.
Should the operator fall overboard or leave
the helm, the lanyard will pull out the lock
plate, stopping ignition to the engine. This
will prevent the boat from running away un-
der power.
EWM00120
WARNING
Attach the engine stop switch lanyard
G
to a secure place on your clothing, or
your arm or leg while operating.
Do not attach the lanyard to clothing
G
that could tear loose. Do not route the
lanyard where it could become entan-
gled, preventing it from functioning.
Avoid accidentally pulling the lanyard
G
during normal operation. Loss of en-
gine power means the loss of most
steering control. Also, without engine
power, the boat could slow rapidly. This
could cause people and objects in the
boat to be thrown forward.
NOTE:
The engine cannot be started with the lock
plate removed.
15
1. Lanyard
2. Lock plate
EMU26090

Main switch

The main switch controls the ignition system;
its operation is described below.
" " (off)
G
With the main switch in the "
tion, the electrical circuits are off, and the key
can be removed.
" " (on)
G
With the main switch in the "
tion, the electrical circuits are on, and the key
cannot be removed.
" " (start)
G
With the main switch in the "
sition, the starter motor turns to start the en-
gine. When the key is released, it returns
automatically to the "
" (off) posi-
" (on) posi-
" (start) po-
" (on) position.