Maintenance
3. To remove the keypad retainer shield:
a. Insert the tip of a "penknife size," flat blade screwdriver in the opening at the end of the
keypad retainer arm tab.
b. Pry the tab away from the side of the front cover until it moves past the ledges on the side
wall. Repeat this procedure for the four remaining retainer arm tabs.
4. Note that the two "top hooks" are still held underneath the front cover—right below the speaker.
Lift the keypad retainer out of the front cover, then lift and pivot the two hooks out of the front
cover.
NOTE: At this point, the Option Board Installation Procedure should be performed, if
necessary. (See page 2-11).
Speaker-Microphone
Flex Circuit Tail
Retainer
Top Hooks
Figure 2-6: Remove Retainer
Retainer
Figure 2-7: Removing the Retainer and Other Boards from the Radio
Keypad Retainer
Arm Tabs (4)
Retainer
Flat Blade
Screwdriver
Option Board
Radio Body
2-7