Setting Up; Power Supply; Using An Optional Ac Power Adaptor; Using Batteries - Yamaha Portatone PSR-530 Owner's Manual

Setting Up

This section contains information about setting up your PSR-530 and preparing to play. Be
sure to go through this section carefully before using your PSR-530.

Power Supply

Although the PSR-530 will run either from an optional AC adaptor or batteries,
Yamaha recommends use of the more environmentally safe AC adaptor. Follow
the instructions below according to the power source you intend to use.

Using An Optional AC Power Adaptor

z Plug an optional Yamaha PA-6 Power Adaptor into a wall AC outlet.
x Then plug the DC output cable from the PA-6 into the DC IN 10-12V jack on
the rear panel of the PSR-530. The internal batteries are automatically
disconnected when an AC Power Adaptor is used.
DC IN 10-12V
When turning the power OFF, simply reverse the procedure.

Using Batteries

For battery operation the PSR-530 requires six 1.5V SUM-1, "D" size, R-20 or
equivalent batteries.
When the batteries need to be replaced "LoBattry" may appear on top of the
display, the volume may be reduced, the sound may be distorted, and other
problems may occur. When this happens, turn the power off and replace the
batteries.
Replace the batteries as follows:
z Open the battery compartment cover located on the instrument's bottom panel.
x Insert the six new batteries, being careful to follow the polarity markings on
the inside of the compartment.
c Replace the compartment cover, making sure that it locks firmly in place.
12
PA-6
• Never interrupt the power
supply (e.g. remove the
batteries or unplug the
AC adaptor) during any
PSR-530 record opera-
tion! Doing so can result
in a loss of data.
• Use ONLY a Yamaha PA-6
AC Power Adaptor (or
other adaptor specifically
recommended by
Yamaha) to power your
instrument from the AC
mains. The use of other
adaptors may result in ir-
reparable damage to both
the adaptor and the PSR-
530.
• Unplug the AC Power
Adaptor when not using
the PSR-530, or during
electrical storms.
• When the batteries run
down, replace them with a
complete set of six new
batteries. NEVER mix old
and new batteries.
• Do not use different kinds
of batteries (e.g. alkaline
and manganese) at the
same time.
• If the instrument is not to
be in use for a long time,
remove the batteries from
it, in order to prevent pos-
sible fluid leakage from
the battery.
• Plugging or unplugging
the AC power adaptor
while the batteries are in-
stalled will reset the PSR-
530 to the defaults.