Calibration Of The Discriminator; Table 33: Commands Of Payment - Azkoyen COMBO-T Technical Information

Payment commands
Code Command
[10H] About
[13H] Request for status
[15H] Cancellation
[19H] Multiple emptying
[20H] Multiple payment
[23H] Last command status
[35H] Intelligent payout
[A3H] Test hopper
[A4H] Enable hopper
[A6H] Request hopper status
[A7H] Dispense hopper coins
[A8H] Request hopper dispense count
[ACH] Emergency stop
Table 33: Payment commands

5.6.7 Calibration of the Discriminator

The calibration is the process of memorization of the measurements of the coins with which you
are going to work. It also makes the adjustment of the offset of the different measurement
sensors, referencing them with a known parameter, such as the diameter of the coin.
All the Discriminators leave factory calibrated, however, it is necessary to make a recalibration
when you remove or change any of the following elements of measurement in the Discriminator:
−
Encoder
−
Trigger
−
Disk
−
Blade
−
Electronics of the optic sensors
−
Optic sensors
It is recommended to do recalibration if the hopper has any physical wear in any of the moving
parts or if it has been dropped or suffered a hard knock.
standard ccTalk /
Specific for discriminator
discriminator
discriminator
discriminator
discriminator
discriminator
discriminator
discriminator
standard ccTalk
standard ccTalk
standard ccTalk
standard ccTalk
standard ccTalk
standard ccTalk
49
10 - 2010