Azkoyen COMBO-T Technical Information page 48

Configuration of the coins Type1 and Type2
The options of configuration of the two types of coins are made through of ccTalk specific
commands for this device. The parameters required to be configured are: the diameter of each
coin and value in units of base coin. It will always be necessary to configure the diameter before
of the value.
Commands of configuration of diameters
−
[25H] Diameter programming
−
[29H] Request for diameters
Commands of configuration of values
−
[31H] Programming value
−
[32H] Value request
Protocol ccTalk for the Discriminator:
For more information on the use of these and other commands, consult the
document Protocolo ccTalk Discriminador_ES.pdf which is available on our
website Azkoyen - Ampasa.
Configuration of the payment mode
The Discriminator allows the payment using two different modes: multiple payment and
intelligent payment.
Multiple Payment
The master defines how many and what types of coins are being paid by the discriminator.
This mode of payment, to be highly efficient, requires the use of comprehensive and dynamic
control of the availability of credit in the hoppers. This requires a homogeneous initial load in
the discriminator and the continuous registering of the coins that enter and leave in the
different transactions
(See chapter 2.7.1 Working principles).
Intelligent Payment
Making use of this mode, the master requests the payment of an amount of base coins from
discriminator and it manages the order making use of the currently prepared coins in the disk.
The smart payment facilitates the control of the cash and keeps the balance of coins in the
hopper at a safe level, making the number the two types of coins proportional.
48
10 - 2010