Electrical Characteristics; Electronic Characteristics; Table 19: V Of Power Supply Of The Hopper; Table 20: Current Draw - Azkoyen COMBO-T Technical Information

5.5.3 Electrical characteristics

•
Voltage of power supply
V power supply
Voltage
Table 19: Voltage of power supply of the Hopper
•
Current draw
Current draw
Max. start up
standby
payment

Table 20: Current draw

5.5.4 Electronic characteristics

Electronic circuit board
The Electronic circuit board of the Hopper is based on a micro-controller with flash memory flash
that allows flash updating of the firmware on site.
To select the ccTalk address of the device and to configure the operation modes, use the block
of 8 dipswitches accessible from the outside.
1. Q1 – Connection ccTalk
2. Q2 – Motor
3. Q3 – Tools - Azkoyen
4. Dipswitches - configuration
5. Q4 – Sensor - full
6. Q5 – Sensor empty
7. Q6 – Sensor Plus
8. Q7 – Con. Exit sensor

Figure 21: Electronic circuit board Hopper U-II ccTalk

12-24VDC ± 10%
3A ± 20%
50 ma ± 5%
450 mA ± 20%
8
7
6
1
5 4 3
10 - 2010
2
36