Advertisement
TYPICAL INSTALLATION
FOR AUTOMATIC PUMP
LU9RICATION. INSTALL
K
A Suction Tube
B Drain Valve
C
Outlet Manifold
D Fluid Filter
E Fluid Outlet Union,
F
Air Regulator
318
npsmlf)
0 Air Inlet Union,
3/4 npsmlfl
J Air Supply Line
K Bld-Type Master Air Valve
L Air Une niter
N
3/4"
Static Grounded
P Grounded Fluid Supply
R Runaway Valve
Air Supply
Hose
Hose
INSTALLATION
l " -
For your safety, read and follow
all
WARNINGS
and instructions in this manus1 and in all supplied
I
your sprayer. Ground the sprayer as explained on
manuals before installing, operating or servicing
moe
3
in
the section
FIRE
OR EXPLOSION
I
~~
~
~~~
~~~
~~
System Components and Accessories
Upstream from the pump air inlet, you should install an
air line filter (L) to remove harmful dirt and moisture
from your compressed air supply. Downstream
from the
for automatic pump lubrication. Downstream from the
air regulator (Fl, you should install an air line lubricator
shut off the air supply to the pump if the pump ac-
lubricator, install a pump runaway control valve
(R)
to
which operates too fast can be seriously damaged.
celerates beyond the pre-adjusted setting. A pump
The sprayer includes an air regulator (F) with a bleed-
type master air valve
(K)
to control pump speed and
fluid pressure.
Connect a grounded fluid hose
IP)
to the
3/8
npsmlf)
Connect the
Hosea
union of the filter outlet manifold
(Cl.
Connect a spray
gun to the fluid hose. Connect a rounded air supply
hose
(Nl
to the air inlet union
(GB.
WARNING
NEVER
operate
the
system with the drain valve
These components are required to reduce the
(B) or bleed-type msster air valves
(Kl
removed.
~
fluid injection, or splashing in the eyes or on the
risk of serious bodily injury from moving parts,
skin, when shutting off the pump.
The bleed-fype air valve relieves air trapped be-
tween the valve and the pump, after the
pump is
shut off. Trapped air can cause the pump to cycle
unexpectedly and result in serious bodily injury
if
you are adjusting or repairing the pump.
The fluid dmin vdv.9 helps relieve fluid pressure in
the displacement pump, hose and gunldispensing
valve when shutting off the pump. Triggering the
gunldispensing valve to relieve pressure may not
be sufficient, especially if there is a clog in the
hose, gunldispansing valve, or tiplnoale.
Advertisement
