Pattfield Ergo Tools BASIC PE-ALB 18 Li Translation Of The Original Instructions page 204

9. Avoid damage and shocks. Replace batteries which have been
dropped from a height of more than one meter or which have
been exposed to violent shocks without delay, even if the housing
of the battery pack appears to be undamaged. The battery cells
inside the battery may have suff ered serious damage. In this res-
pect, please also read the waste disposal information.
10. If the battery pack suff ers overloading and overheating, the inte-
grated protective cut-off will switch off the equipment for safety
reasons. Important. Do not press the ON/OFF switch any more if
the protective cut-off has actuated. This may damage the battery
pack.
11. Use only original battery packs. The use of other batteries may re-
sult in injuries, explosion and a fi re risk.
Information on chargers and the charging process
1. Please check the data marked on the rating plate of the battery
charger. Be sure to connect the battery charger to a power supply
with the voltage marked on the rating plate. Never connect it to a
diff erent mains voltage.
2. Protect the battery charger and its cable from damage and sharp
GB
edges. Have damaged cables repaired without delay by a quali-
fi ed electrician.
3. Keep the battery charger, batteries and the cordless tool out of
children's reach.
4. Do not use damaged battery chargers.
5. Do not use the supplied battery charger to charge other cordless
tools.
6. In heavy use the battery pack will become warm. Allow the battery
pack to cool to room temperature before commencing with the
charging.
7. Do not over-charge batteries. Do not exceed the maximum
charging times. These charging times only apply to discharged
batteries. Frequent insertion of a charged or partly charged batte-
ry pack will result in over-charging and cell damage. Do not leave
Anl_PE_ALB_18_Li_Basic_SPK7.indb 204 Anl_PE_ALB_18_Li_Basic_SPK7.indb 204
- 204 -
21.01.16 16:02 21.01.16 16:02