Ethernet Ports; Setting Up Your Recovery Series Appliance - Kaseya Unitrends Recovery Series Quick Start Manual

Quick Start Guide for Recovery Series
Appliances
Release 10.4.8 | October 2020
•
A network domain name.
Note: You can obtain the above information from your network administrator.

Ethernet ports

Ethernet ports are located on the back of the appliance. Connect Ethernet cables to these ports prior to powering on the
appliance:
•
Primary Ethernet port (required) – Connect one cable to the primary Ethernet port. The primary Ethernet port is
configured with DHCP by default. See the images below to locate the primary Ethernet port on your appliance
(outlined in green).
•
iDRAC port (recommended) – Connect one cable to the iDRAC port. For increased security, we recommend that you
keep the iDRAC connection inaccessible to the WAN. See the images below to locate the iDRAC Ethernet port on
your appliance (outlined in red).
•
Appliance models 9002, 9004, 9006, 9008, 9010, and 9012:
•
Appliance models 9016S, 9020S, and 9024S:
•
Appliance models 9032S, 9040S, 9060S, 9080S, 9100S, and 9120S:

Setting up your Recovery Series appliance

Use the following procedures to set up your appliance. These procedures assume you have attached a monitor,
keyboard, and mouse to the appliance.
•
"Step 1: Set up the appliance on the
•
"Step 2: (Recommended) Configure a network port for iDRAC "
network".
Quick Start Guide for Recovery Series Appliances
5