Step 11: Install The Velcro To The Outside Of The Tailgate - Softopper International Scout 80/800 Installation Instructions Manual

Step 10
Insert the 2- 12 inch 3/4" bars into each
end of the longer 44" bar with the plastic end
caps out. Press the bar assembly into the black
plastic snap fit parts on the rear of the bedrail,
adjusting the total length as necessary for a tight
side to side fit. It is ideal to have the larger tube
centered and have as little side to side
movement as possible. Using the drill and the #2
phillips drill bit carefully screw in the 2 self
drilling screws to join the large and small bars.
There are 2 predrilled holes in each end of the
large bar. Insert the finished tube into the rear
window panels inside sleeve. Press the rear bar
into the snap fit parts again and check
fit.! ! ! ! ! ! ! ! ! !
Not to Scale
Step 11
Install the velcro to the outside of the tailgate to better secure the rear window panel
in place. It is recommended that you clean the surface with a 50/50 mix
of water and isopropyl alcohol.
Retracting
When retracting the top it is recommended that you
flip the sides and rear neatly up onto the roof and
carefully fold the canopy rearward as neatly as
possible. It is highly recommended that the boot
cover / storage bag is used when the topper is in the
retracted position. This will prevent the top from
catching the wind.
If you decide to use the supplied Seam sure, be sure
to apply it to the inside of the canopy. Do not allow
the liquid to come in contact with the outer vinyl
coating of the canopy.
1-800-810-7227 www.softopper.com Page 5