U-Line H-3504 Assembly Instructions
U-Line H-3504 Assembly Instructions

U-Line H-3504 Assembly Instructions

Garage canopy 7'7" x 12' x 7'8"

Advertisement

Quick Links

π
H-3504
garage canopy
7'7" x 12' x 7'8"

TOOlS NEEDED

Safety Glasses
Tape Measure
A. 69" Pipe x 16
B. 36" Pipe x 6
C. 3-Way Fitting x 6
CAUTION! Keep all flame and heat sources
away from tent fabric. The tent fabric will
burn if left in continuous contact with any
flame source.
DO NOT cook underneath or near canopy.
DO NOT store or use flammable liquids
underneath or near canopy.
DO NOT ignite or store fireworks underneath or
near canopy.
DO NOT use bleach to clean cover.
DO NOT dry clean cover.
PAGE 1 OF 3
1-800-295-5510
uline.com
Wrench or Socket
9/16" or 14mm
Phillips Screwdriver
D. 4-Way Fitting x 3

PARTS

E. Metal Foot Pad x 6
F. Foot Pad Stake x 12
G. Cover With Rear Wall & Sides x 1

SAFETY

DO NOT wash cover in washing machine or dry
in dryer. Hand wash with mild soap and water only.
DO NOT allow rain water, snow or ice to
accumulate on top of cover.
DO NOT hang or suspend anything from the
frame, grommets, truss system or ball straps of
the unit.
REMOVE canopy cover before a storm, or
disassemble entire canopy unit if possible.
NOTE: This is a temporary structure and is
not recommended for use as a permanent
structure.
Rubber Mallet
H. Zippered Front Wall x 1
I. Elastic Ball Strap x 35
K. Double Side
J. Single Side
Pipe Clamp x 2
Pipe Clamp x 4
0714 IH-3504

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the H-3504 and is the answer not in the manual?

Questions and answers

Summary of Contents for U-Line H-3504

  • Page 1 π H-3504 1-800-295-5510 uline.com garage canopy 7'7" x 12' x 7'8" TOOlS NEEDED Safety Glasses Wrench or Socket 9/16" or 14mm Tape Measure Phillips Screwdriver Rubber Mallet PARTS A. 69" Pipe x 16 E. Metal Foot Pad x 6 H. Zippered Front Wall x 1 B.
  • Page 2 ASSEMBlY ROOF FRAME ASSEMBLY COVER ASSEMBLY Start top frame assembly as shown. (See Figure 1) With frame assembled and cover on, you can now The 36" pipes are used for the roof rafters and 69" attach cover to frame using the ball straps. The pipes form the length of the frame.
  • Page 3 ASSEMBlY CONTINUED COVER ASSEMBLY CONTINUED ANCHORING THE UNIT 4. Your storage shelter can be used with or without the NOTE: the canopy is designed for use as front zipped wall. If you choose to use your front wall, a temporary structure. After assembly, the install it with Velcro®...

Table of Contents