Advertisement
Quick Links
π
H-3505
GARAGE CANOPY
10'
20'
8'
X
X
TOOLS NEEDED
Safety Glasses
Tape Measure
2-way Corner
3-way Center
Foot Pad x 4
Foot Pad x 6
58" Pipe x 28
21.5" Pipe x 10
45" Curved Pipe x 20
CAUTION! Keep all flame and heat sources
away from tent fabric. The tent fabric will burn
if left in continuous contact with any flame
source.
DO NOT cook underneath or near canopy.
DO NOT store or use flammable liquids
underneath or near canopy.
DO NOT ignite or store fireworks underneath or
near canopy.
DO NOT use bleach to clean cover.
DO NOT dry clean cover.
PAGE 1 OF 5
1-800-295-5510
uline.com
Wrench or Socket
9/16" or 14mm
Phillips Screwdriver
3-way End
4-way Center
Connector x 10
Connector x 15
60' Rope For Assembly x 1
PARTS
Ball Straps x 70
Cover x 1
SAFETY
DO NOT wash cover in washing machine or dry
in dryer. Hand wash with mild soap and water only.
DO NOT allow rain water, snow or ice to
accumulate on top of cover.
DO NOT hang or suspend anything from the
frame, grommets, truss system or ball straps of
the unit.
REMOVE canopy cover before a storm, or
disassemble entire canopy unit, if possible.
NOTE: This is a temporary structure and is
not recommended for use as a permanent
structure.
Rubber Mallet
Cables x 5
Front Wall
With Zippers x 1
Back Wall
With Zippers x 1
Anchor x 6
0514 IH-3505
Stake x 10
Screw-in
Ground
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for U-Line H-3505
Summary of Contents for U-Line H-3505
- Page 1 π H-3505 1-800-295-5510 uline.com GARAGE CANOPY TOOLS NEEDED Safety Glasses Wrench or Socket 9/16" or 14mm Tape Measure Phillips Screwdriver Rubber Mallet PARTS Cables x 5 2-way Corner 3-way Center 3-way End 4-way Center Ball Straps x 70 Foot Pad x 4...
-
Page 2: Frame Assembly
FRAME ASSEMBLY NOTE: For faster and easier set up, assembly by Tie frame from end to end down the center. two or more people is recommended. (See Figure 3B) Lay parts out as shown. (See Figure 1) 58" 4-way Straight Pipe 33.5"... - Page 3 COVER AND LEGS ASSEMBLY CONTINUED Remove cover from plastic bag and unfold. Next 5. Once you have secured top to curved section fold half the cover over the other half with the of frame, finish frame assembly. Assemble the white side out. Match the corners (See Figure 6A) remaining frame on each side using the 21.5"...
-
Page 4: Anchoring The Unit
COVER AND LEGS ASSEMBLY CONTINUED With the canopy standing and cables in place, 9. Add the canopy end walls using the Velcro straps anchor the canopy using the foot stakes provided. and then secure them using the ball straps. Next, (See Figure 13) Driving the stakes in at an angle will tighten and secure the drawstrings at each corner help anchor the canopy more securely. - Page 5 ANCHORING THE UNIT CONTINUED 2. Unloop the cable from the anchor eye and slide 3. When you have tightened the clamp and satisfied the clamp onto cable. Run cable around the that the cable will not slip, you may tighten the pipe, (See Figure 18) and then back through the cable more by turning the anchor further in the clamp.
Need help?
Do you have a question about the H-3505 and is the answer not in the manual?
Questions and answers