Troubleshooting - Hama 121955 Operating Instructions Manual

Note
On extending Hama radio-controlled socket sets. It cannot be
guaranteed that radio remote controls of other manufacturers
will work.
5. Learn function of the radio-controlled socket
Press and hold the "LEARN" button for approx.
3 seconds until the LED starts to flash. Then select the desired
channel by pressing the corresponding "ON" button.
The LED on the radio-controlled will stop blinking when it has
successfully learnt the frequency.
If the learning is unsuccessful, the remote control socket will leave
learn mode after 15 seconds. In this case, repeat the process. It is
also possible to assign a channel multiple times (multiple radio-
controlled sockets can respond to the same remote control button).
If you wish to delete a programmed channel, first press the
"LEARN" button until the LED flashes. Press the "OFF" button for
the channel to remove its programming.

6. Troubleshooting

6.1 Remote control does not work
Check whether the battery has been inserted with the poles facing
the proper directions. You can check this by making sure that the
label on the battery corresponds to the polarity marked inside the
battery compartment.
If the control LED on the remote control does not light up when you
press a button, even when the battery has been inserted correctly,
then it is possible that the remote control has a technical defect.
If this is the case, please contact our customer service team or the
retailer where you purchased this product.
6.2 The radio-controlled socket cannot be switched on or
off even though the remote control is working properly
Repeat the steps above under "Learn function of the radio-
controlled socket" and, if necessary, contact Hama technical
support or the retailer where you purchased this product.
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do
not use aggressive cleaning agents.
Note
Disconnect the device from the power supply before cleaning
or if it will not be used for a long period of time.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/mounting,
improper use of the product or from failure to observe the operating
instructions and/or safety notes.
9. Technical Data
Input voltage
Output voltage
Maximum connection
power
Signal frequency
Transmitter duty cycle
Receivers category
10. Recycling Information
Note on environmental protection:
After the implementation of the European Directive
2012/19/EU and 2006/66/EU in the national legal
system, the following applies: Electric and electronic
devices as well as batteries must not be disposed of
with household waste. Consumers are obliged by law
to return electrical and electronic devices as well as batteries at the
end of their service lives to the public collecting points set up for
this purpose or point of sale. Details to this are defined by the
national law of the respective country. This symbol on the product,
the instruction manual or the package indicates that a product is
subject to these regulations. By recycling, reusing the materials or
other forms of utilising old devices/Batteries, you are making an
important contribution to protecting our environment.
11. Declaration of Conformity
Hereby, Hama GmbH & Co KG declares that the radio
equipment type [00121955] is in compliance with
Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet
address:
www.hama.com -> 00121955 -> Downloads.
230 V~/50 Hz/16 A
230 V~/50 Hz/16 A
16 (2) A, 3680 W;
i.e. up to 16 A for resistive
loads and up to 2 A for
inductive loads
433.92 MHz
< 10 %
Class 3
3