Yamaha Electone EL-87 Owner's Manual page 89

3
Insert the source disk into the disk slot.
The M.D.R. starts reading the data in the source disk.
"out 1" appears on the LED display.
4
Press the eject button to take out the source disk.
"In 2" appears on the LED display to urge you to
insert the destination disk.
5
Insert the destination disk.
The number "160" appears on the LED display and
counting down is initiated as the disk is being copied.
"out 2" appears on the LED display.
6
Eject the destination disk.
"In 1" appears on the LED display again.
7
Repeat the procedures #3 through #6 as indicated on
the LED display.
The number of times you repeat depend on the size
of the data to be copied and the disk type (2DD type:
2 ~ 16 times; 2HD: 2 ~ 31).
When finished, "End" will appear on the LCD display
for 2 or 3 seconds.
N O T E :
"Fort" or "bAd" may appear if an error occur in the
middle of the operation. If this happen, please retry
formatting the destination disk and copying disk.
Follow the M.D.R. direction to eject/insert the disks
durinmg the operation. Do not eject/insert the disks
frivolously ignoring the M.D.R. direction. Doing so
can damage the disk and possibly the disk drive.
N O T E :
If you want to cancel the Disk Copy operation in the
middle of procedures, eject the disk and turn the power
off. In this case, you are required to format the destination
disk again.
85