Yamaha Electone EL-400 Owner's Manual page 19

2
Press one of the Data Control buttons that corresponds to the voice you
wish to select. (Pop Organ 1, in this case)
DATA CONTROL
The first letter of the selected voice/rhythm will start blinking. You
have selected Pop Organ 1 for the Upper Keyboard Voice 1.
3
If you wish to, you can select voices from the other Upper Keyboard
Voice sections, Upper Keyboard Voice 2 and Lead Voice, Lower
Keyboard Voice sections and Pedal Voice sections, following steps #1
and #2 above.
4
Set the volume for each voice section.
There are two volume controls:
Coarse:
Use the VOLUME controls of each voice section on the panel to set the
desired level for each voice. The controls have seven volume settings,
from a minimum of 0, or no sound, to a maximum of full volume.
UPPER KEYBOARD VOICE 1
STRINGS BRASS CLARI-
NET
ORGAN PIANO GUITAR
Fine:
Pressing the same panel voice button again (or the same Data Control
button corresponding to the selected voice) calls up the Voice
Condition display. Use the Page buttons to select page 2, which
contains Volume setting.
DATA CONTROL
MAX
SAXO- CHORUS HARMO- 1
PHONE NICA
VIBRA- COSMIC TUTTI
2
PHONE
MIN
DATA CONTROL
The voices, Upper Keyboard Voice 2,
Lower Keyboard Voice 2 and Pedal Voice
2, is selectable using the Dotted buttons.
The detail is shown on page 21.
UPPER KEYBOARD
VOICE 2
MAX
1
2
MIN
DATA CONTROL
NOTE:
PAGE
2
19