To Remove, Replace And Set Needle And Nipple - Consew 104-1T Parts Book And Instruction Manual

TO REMOVE, REPLACE AND SET NEEDLE AND NIPPLE

When it is necessary to change the needle and nipple on the machine,
first select another n eedle and corresponding nipple. Then lower the
presser bar, loosen wing screw B, Fig. 3 and remove needle hol der A and
needle from top of machine. Unscrew
provided.
Select the correct needle hole in needle plate D.
NOTE: The needle hole should be slightly larger than the needle, so that
the needle, when laid around the needle, will have sufficient space to pass
without touching the sides of the needle hole.
Loosen thumb screw L and turn plate D until correct needle hole is in line
with needle, then tighten thumb screw L.
Next, screw selected ni pple into th e lower end of nipple carrier O and
tighten securely with the small wrench. Screw selected needle into either
end of needle hol der A and tighten with pliers provided. Repl ace needle
holder A down into sleeve and adj ust its height so that the fabric to be
embroidered can just under the point of the needle.
Be sure handle K is as far to the front as possible and that the hook of the
needle faces the front. Then tighten wing screw B, wh ich also should face
the front.
nipple N, using the small wrench
5