After Installation; First Start-Up - Siemens DE06111 Installation And Operating Instructions Manual

After installation

DE05101, DE06101, DE06111, DE08101
and DE08111 (ixed electrical connection)
Switch on the fuses.
DE04101 and DE10104
Insert the plug into the mains socket.
■

First start-up

Initial rinsing
Open the warm water tap and allow water to
■
low for at least 1 minute (low-rate at least
2 litres per minute). Only then (for safety rea-
sons) will the appliance begin to heat.
Info: The appliance will not heat if the dispensed
water low is interrupted prematurely. Open the
warm water tap again and allow water to low
for at least 1 minute.
Tip: Should the appliance not start because of a
reduced low-rate, remove the perlator, aerator or
similar before starting and repeating the process.
Important
H1
24
en
H2
Important: If the continuous-low heater does not
have suficient water low due to low water line
pressure in your domestic plumbing system:
Switch off the circuit-breakers/fuses or remove
■
the mains plug.
Remove the low-rate limiter (
■
Controlling temperature
The supply temperature (probably lower in winter)
and pressure luctuations can inluence the tem-
perature of the water leaving the tap (refer to igure
on page 22).
Turn the valve slowly in the closed direction for
■
higher temperatures (F1).
Add cold water for lower temperatures (
■
Hand over the installation and operating instruc-
■
tions to the user and explain how the appliance
operates.
H3
H1 – H4).
F2).
H4