YELLOWRIVER YR-P0319SIR User Manual
  1. Manuals
  2. Brands
  3. YELLOWRIVER Manuals
  4. DJ Equipment
  5. YR-P0319SIR
  6. User manual

YELLOWRIVER YR-P0319SIR User Manual

Led par light (infrared control）
Hide thumbs
1
2
3
4
5
6
7
8
9
Table of Contents

Advertisement

Quick Links

Download this manual
LED PAR LIGHT（infrared control）
Model: YR-P0319SIR
(R4/G5/B5/W5)
Con

Advertisement

Table of Contents
loading

Related Manuals for YELLOWRIVER YR-P0319SIR

Summary of Contents for YELLOWRIVER YR-P0319SIR

  • Page 1 LED PAR LIGHT（infrared control） Model: YR-P0319SIR (R4/G5/B5/W5)
  • Page 2 tents Section 1.Getting Started  Unpacking  Safety Instruction Section 2. Set Up  Installation  Controlling Board  Machine Connection Section 3. Troubleshooting  Troubleshooting Section 4. Reference  Control Menu  DMX Protocol  Specification Section 5. IR Controller...

  • Page 3: Section 1. Getting Started

    Section 1. Getting Started  Unpacking Safety Instruction  Unpacking  1pc Fixture  1pc User Manual  1pc Power switchable Cable  1pc Signal Cable  IR controller Thanks for using our LED PAR LIGHT range. Carefully unpack the box and check the contents to ensure that all parts are present and in good conditions.

  • Page 4: Safety Instruction

    Caution! There are no user serviceable parts inside the unit. Do not open the housing or attempt any repairs yourself. In the unlikely event your unit may require service, please contact your local distribution or after-sale service center. Safety Instruction For your safety，please read this user manual carefully before operation.

  • Page 5: Section 2. Set Up

    Section 2. Set Up  Installation  Controlling Board  Machine Connection Installation This machine should be mounted through the screw holes of truss. Safety wire is a must to fix fixture well. Make sure truss and safety wire have strong load capacity to bear 3 times weight than fixture at least.

  • Page 6: Specification

    3. DMX signal input Control model by DMX signal，please use 3pin XLR signal cable. 4. DMX Signal output Controlling Board AND Front display panel Transfer DMX signal to next model, please use 3pin XLR signal cable. 5. Power PLUG Connect to obtain power (attention：please use connect to stated voltage.) Display Display menu and selected function.
  • Page 7 Machine Connection DMX protocol DMX512 Channel Chart：（5CH） Function Specification Dimmer R G B W color from dark to bright Cable Connectors R dimmer Red color from dark to bright Cables must have a male XLR connector on one end and a female XLR connector on the G dimmer Green color from dark to bright other end.

  • Page 8: Section 3. Troubleshooting

    channel-7 or 11CH) Probable cause(s) Remedy Section 4. Reference No power to fixture Check power cables No response from  Control Menu Primary fuse blown Replace fuse fixture when power Secondary fuse  DMX Protocol is applies Replace fuse blown Specification ...
  • Page 9 Section 5.IR controller Controlled by IR only OFF- LED OFF ON – ALL LED FULL BRIGHT COLOR CHOOSE AREA- CHOOSE THE COLOR YOU WANTED UP/DOWN- PRESS IT TO CHANGE THE BRIGHTNESS OF THE COLOR OR SPEED OF STROBE/COLOR CHANGE/FLADE OR DETECTION SENSE OF SOUND ACTIVE.

Table of Contents