Daily Use - Drying Only - Zanussi Z716WT83BI User Manual

Non-automatic wash&dry programmes
In some washing programmes, you can combine
Mode - Wash and Mode - Dry for running a
complete wash&dry programme.
Proceed as follows:
1. Press the On/Off button for some seconds to
activate the appliance.
2. Load the laundry one item at a time.
3. Put the detergent and the additives in the
appropriate compartment.
4. Turn the programme dial to the washing
programme. The appliance defaults to the
washing only mode and the indicator of the
Mode - Wash button is on. The display shows
the default temperature and spin. If necessary,
change them according to your laundry.
5. Set the desired options, if there are available.
6. Tap on the Mode button once to activate also
the drying function. Both indicators of the
Mode - Wash and Mode - Dry buttons are on.
The indicator appears on the display.
WASHING AND DRYING - AUTOMATIC
LEVELS
1. Tap on the Auto Dry button repeatedly until the
display shows the required dryness level. The
indicators in the display illuminate accordingly:
a. Iron dry: for cotton items;
b. Cupboard dry: for cotton and
synthetic items;
c. Extra dry: for cotton items.
The time value on the display is the duration
of both cycles washing and drying, calculated
on a default load size.
To have a good drying by using less
energy and in a shorter time, the
appliance does not let you set a too
low spin speed for the items to be
washed and dried.
2. Touch button Start/Pause
programme. The AutoAdjust estimation starts.

DAILY USE - DRYING ONLY

WARNING! Refer to Safety chapters.
This appliance is an automatic washer
dryer.
34
In the display the door locked
on.
The display also shows the remaining programme
time.
WASHING AND TIMED DRYING
1. Tap on the Time Dry button repeatedly to set
Each time you tap on this button the time value
increases by 5 minutes. The display shows the set
new time value.
2. Touch the Start/Pause
In the display the door locked
on.
The display also shows the remaining programme
time.
AT THE END OF THE DRYING PROGRAMME
•
•
•
•
•
1. Remove the laundry from the appliance.
2. Make sure that the drum is empty.
to start the
PREPARATION TO DRYING
1. Press the On/Off button for some seconds to
2. Load the laundry one item at a time.
3. Turn the programme dial to the programme
the desired time value (see the "Timed drying"
table the "Programmes" chapter). The drying
level indicator goes off and the indicator
comes on.
programme. The AutoAdjust estimation starts.
The appliance stops automatically.
The acoustic signals operate (if they are active).
In the display comes on.
The indicator of the Start/Pause
goes off. The door locked
and the door unlocks.
Press the On/Off button for some seconds to
deactivate the appliance.
After some minutes from the end of
the programme, the energy saving
function deactivates the appliance
automatically.
After drying phase, clean the drum, the
seal and the inside of the door with a
wet cloth.
activate the appliance.
suitable for the items to dry. The appliance
defaults to the washing only mode and the
indicator of the Mode - Wash button is on.
indicator comes
button to start the
indicator comes
button
indicator goes off