Zanussi Z716WT83BI User Manual page 17

1
2
E
D
C
ELECTRICAL CONNECTION
At the end of installation you can connect the mains
plug to the mains socket.
The rating plate and the 'Technical Data' chapter
indicate the necessary electrical ratings. Make sure
that they are compatible with the mains power
supply.
Check that your domestic electrical installation can
take the maximum load required, also taking into
account any other appliances in use.
Connect the appliance to an earthed socket.
Counter-magnet
The appliance is pre set for a magnetic closure.
For a correct closure:
1. Position the screw C and the counter-magnet D
N
2. Open the cupboard door and screw the coun-
The power supply cable must be easily accessible
after installing the appliance.
For any electrical work required to install this
appliance, contact our Authorised Service Centre.
The manufacturer does not accept any
responsibility for damage or injury through failure to
comply with the above safety precaution.
on the magnetic plate N. Lean the cupboard
door against the screw until it leaves a mark.
ter-magnet D (steel disk + rubber ring E) with
the screw C in the inner side of the cupboard
door, where the screw left the mark as descri-
bed in the first step.
17