Remove Access Panel - Whirlpool WDT750SAKW Owner's Manual

Remove Access Panel

– For Plastic Access Panels, go to step 9
– For Metal Access Panels, go to step 10
9. Plastic panel
Using a flat-blade screwdriver, turn the plastic fasteners 1/4
turn counterclockwise to unlock them. Go to step 12.
10. Metal panel
Using a 1/4" (6.35 mm) nut driver or Phillips screwdriver,
remove 2 screws attaching access panel to dishwasher.
11. Measure cabinet opening
Measure height of cabinet opening from underside of
countertop to floor where dishwasher will be installed. Be
sure to measure the lowest point on the underside of the
countertop and the highest point on the floor.
Dishwasher Height Adjustment Chart
Cabinet-opening
height
33 1/2" (851 mm)
34" (864 mm)
34 1/2" (876 mm)
Front legs – A
Rear legs – B
Adjust both front and back leveling legs to the same height.
NOTE: If the minimum cabinet opening height is less than
33 7/8" (860 mm), the rear leveling legs and spacers can be
removed for additional clearance. This will allow the
dishwasher to fit into a 33 1/2" (851 mm) high cabinet
opening, but the dishwasher will be more difficult to move.
(Measurements are approximate. Rear and front leveling
legs are preset at the factory for 34 1/2" [876 mm].)
Front legs height Rear legs height
A B
3/8" (9.8 mm) Remove legs and
spacers.
7/8" (22 mm) 1" (25.4 mm)
1 1/8" (28.8 mm) 1 1/4" (31.3 mm)
11