Miele KSK 28202 edt Side-By-Side Installation page 27

Installation instructions from the
back of the appliances
 Fit connecting clamp  at the top
over the middle two side walls.
 Then fit the connecting bracket 
into the appropriate gap below it.
 Tighten connecting bracket firmly 
with screw .
Warning: do not drill a hole for this
screw in the appliance!
Tip:
To avoid vibrations, neither the clamps,
brackets nor the screws should touch
the pipework on the back of the appli-
ances.
en - Installing in a side-by-side combination
Further installation instructions from
the front of the appliances
Danger of damaging the plinth
rollers.
When aligning the appliances by the
rear adjustable feet do not use a
power screwdriver. Doing so could
damage the height adjustment
mechanism or loosen the adjuster
rods. The adjustable feet must only
be adjusted by hand.
 The front adjustable feet should be
adjusted using the spanner supplied
.
 Adjust the central adjustable feet 
so that they do not touch the floor.
 Now align the whole side-by-side
combination with the outside ad-
justable feet .
27