Product Overview; Adjusting The Metal Detector To Your Body Height - Renkforce MD 150 Operating Instructions Manual

7. Product overview

1
2
3
4
14

8. Adjusting the metal detector to your body height

The product is delivered fully assembled.
Follow the steps below to adjust the length of the pole:
26
5
6
7 8
9
13
12
11
10
• Change the length of the pole to adjust the metal detector to suit your height.
• Adjust the length of the pole to your height so that you can comfortably move the
detection probe (1) over the ground at a height of approximately 3 - 5 cm without
having to bend over. When searching for metallic objects, ensure that you stand
straight with a balanced body posture. The figure to the left is schematic.
• Loosen the connection sleeve (3) by turning it clockwise.
1 Detection probe
4
2 Lower telescopic pole
3 Connection sleeve
4 Upper telescopic pole
5 Analogue display
6 VOLUME dial
7 DISCRIMINATION dial (not shown)
8 Handle with push button (reset button)
9 Battery test switch
10 Headphone jack (not shown)
11 TUNE dial
12 Battery compartment (on the rear/not shown)
13 Control unit
14 Swivel joint (secured with knurled nuts)