Yamaha 03D Application Manual page 40

• On the Tascam (CD8-TD) card there is a DIP switch that should be set to 16-bit. This is
the initial setting, but you should confirm it. This switch is for use with Tascam High-Bit
recording applications.
• The rear of the Cascade (CD8-CS) card has an IN/OUT switch. For 02R–A this must be
set to OUT. On 02R–B it must be set to IN.
• The optional CD8-CS kit contains two CD8-CS cards and one 25-pin straight cable.
DA-88–B
ID=1
TDIF-1
DA-88–A
ID=0
TDIF-1
WC OUT
(BNC)
Optional SY-88 Sync Board installed
Rear panel DIP switches 2 and 5=O
SMPTE timecode
Wordclock
CD8-TD
Switch=OUT
WORD
1 2 3 CLOCK
IN (BNC)
CD8-CS
(75 =ON)
02R–A
WORD
CLOCK
OUT (BNC)
Figure 12 Two 02Rs with Four DA-88s
PW-88S 15-pin cable
SYNC OUT
SYNC IN
PW-88S 15-pin cable
SYNC OUT
SMPTE OUT
or MTC OUT
(phono)
or MTC
CD8-TD
25-pin straight
cable
SMPTE
TIMECODE
1 2
INPUT
(phono)
DIGITAL RECORDING CONSOLE
02R–B
WORD
CLOCK
IN (BNC)
(75 =ON)
02R Applications 35
DA-88–C
SYNC IN
ID=2
TDIF-1
SYNC OUT
PW-88S 15-pin cable
DA-88–D
SYNC IN
ID=3
TDIF-1
SYNC OUT
Terminator
The power amp, monitors, and
DAT recorder have been removed
from this diagram for clarity.
Switch=IN
SMPTE
TIMECODE
3
INPUT
CD8-CS
(phono)
DIGITAL RECORDING CONSOLE
Stereo fader, Bus
master, & Aux
master controls on
this 02R are used.
Yamaha 02R & 03D Applications Guide