Table of Contents
Advertisement
Note：on vacuum process, carefully observe the vacuum table pointer, when the pointer has
reached
the red scale area, cut off the compressed air, complete the
pumping
operation.
2）Periodic Inspection
1）Leak check
2）Oil leak check
3) Make sure that the hose and fittings are not damaged, deformed, worn or stained.
Note: On a regular basis, it is recommended that professional personnel manage the product
and
do the inspections. For details, please consult the vendors.
3）Complete Inspection
After the end of the operation, the products must be free of adhered materials or stains
(water, debris, oil, etc.) wipe clean. If there is abnormal signal, immediately contact the seller.
4) Other Considerations：
Attention
1. Inspection Notes
1）Please, do pre-work and regular inspection, according to the content of this guide.
2）Do not use this product without pumping oil not connected.
2．Use matters attention
1）This product is strictly prohibited for contacting with fire or corrosive liquid；
2）Don NOT go beyond the usual pressure range when used。
10. Troubleshooting
Please first read the instruction manual carefully and check the following items. If you are still
doubting on the procedure, please contact the vendor.
Fault
Vacuum degree is
not enough
ADD: Huli Industrial Zone, NO.4 Xinwei Industrial Estate, Gongming Office, Guangming District, Shenzhen , China.
TEL: 86 0755 61136563 FAX: 86 0755 27125016
SHENZHEN FABIT M&E EQUIPMENT CO. LTD.
Reason
Lack of air pressure
Broken cup
Vacuum table damage
In addition to the intake valve,
the mouth of the cup is is not
closed
Vacuum generator damage
Adjust the flow pressure to
achieve the specified pressure.
Contact vendor for replacement
Contact vendor for replacement
In addition to close the cup
external inlet， close all ball
valves
Contact vendor for replacement
E-mail:
fabit@vip.163.com
vacuum
Processing Method
WEBSITE: http: //www.fabit.cn
11
Advertisement
Table of Contents
